SP030 adhesive sealant

Description
SP030 is a transparent adhesive sealant based on Tremco illbruck’s SP polymer technology.
Colours
Crystal clear
Packaging
310 ml tube (12 per carton)

 

 

Technical data

 

 

 Property

 Test method

 Results

 Composition

 

 SP polymer

 Specific gravity

 DIN 52 451-A

 1.04

 Consistency

 EN 27 390,20

 0 mm, non-sagging

 Shore A hardness

 

 28

 Shrinkage

 DIN 52 451

 2.7%

 Secant modulus at 100%
 elongation

 EN 28 340

 0.6 N/mm

 Tensile strength

 DIN 53 504 S2

 2.0 N/mm

 Elastic
 recovery

 EN 27 389-B

 > 50%

Permitted deformation

 

20%

 Curing time

 20 °C

 approx. 3.5 mm per day

 Skinning time

 20 °C and 50% RH

 approx. 10 minutes

 Application temperature

 

 +5 to +40 °C

 Service temperature range

 

 -40 °C to +80 °C

Storage

 

Store in a dry and shaded place between +5 °C and +25 °C

 Shelf life

 

 12 months

 

Preparation

  • It is recommended to carry out an adhesion test prior to final use.
  • Surfaces must be clean, dry, and free of dust and grease.
  • Roughen non-porous surfaces.
  • On materials such as glass, aluminium, ceramics, lacquered wood, PVC, epoxy, and polyester, no primer is required.

Application

  • Cut off the end of the thread of the tube with a sharp knife, avoiding damage to the thread. Trim the nozzle to the required diameter.
  • Ensure proper contact between the joint surfaces before applying adhesive. Apply a bead of adhesive to one or both surfaces. For larger surfaces, apply the adhesive using a suitable spreader.
  • Bring the two surfaces together immediately and hold together for 30 minutes until sufficient bond strength has developed.
Coverage  
 Width x depth (mm) Linear metres per 310 ml tube
 5 x 5  12,4
 8 x 6  6,4
 10 x 8  3,8
 15 x 10  2,0
 20 x 12  1,2
 25 x 15  0,8
 30 x 15  0,6

Cleaning
Remove excess adhesive immediately with AT200 High Strength Cleaner. Ensure that the surface is solvent-resistant before cleaning. Cured adhesive can only be removed mechanically.
Note! SP050 is not suitable for bonding polyethylene, polypropylene, Teflon®, or nylon surfaces.
Bonding laminates and synthetic materials are also counter-indicated as they may be prone to cracking due to stresses.
Not suitable for use in glass joints (structural glazing).

Health and safety precautions
Safety data sheet must be read carefully before use.