| Description SP030 is a transparent adhesive sealant based on Tremco illbruck’s SP polymer technology. Colours Crystal clear Packaging 310 ml tube (12 per carton) |
|
| Technical data | ||
| Property | Test method | Results |
| Composition | SP polymer | |
| Specific gravity | DIN 52 451-A | 1.04 |
| Consistency | EN 27 390,20 | 0 mm, non-sagging |
| Shore A hardness | 28 | |
| Shrinkage | DIN 52 451 | 2.7% |
| Secant modulus at 100% elongation |
EN 28 340 | 0.6 N/mm |
| Tensile strength | DIN 53 504 S2 | 2.0 N/mm |
| Elastic recovery |
EN 27 389-B | > 50% |
| Permitted deformation | 20% | |
| Curing time | 20 °C | approx. 3.5 mm per day |
| Skinning time | 20 °C and 50% RH | approx. 10 minutes |
| Application temperature | +5 to +40 °C | |
| Service temperature range | -40 °C to +80 °C | |
| Storage | Store in a dry and shaded place between +5 °C and +25 °C | |
| Shelf life | 12 months |
Preparation
- It is recommended to carry out an adhesion test prior to final use.
- Surfaces must be clean, dry, and free of dust and grease.
- Roughen non-porous surfaces.
- On materials such as glass, aluminium, ceramics, lacquered wood, PVC, epoxy, and polyester, no primer is required.
Application
- Cut off the end of the thread of the tube with a sharp knife, avoiding damage to the thread. Trim the nozzle to the required diameter.
- Ensure proper contact between the joint surfaces before applying adhesive. Apply a bead of adhesive to one or both surfaces. For larger surfaces, apply the adhesive using a suitable spreader.
- Bring the two surfaces together immediately and hold together for 30 minutes until sufficient bond strength has developed.
| Coverage | |
|---|---|
| Width x depth (mm) | Linear metres per 310 ml tube |
| 5 x 5 | 12,4 |
| 8 x 6 | 6,4 |
| 10 x 8 | 3,8 |
| 15 x 10 | 2,0 |
| 20 x 12 | 1,2 |
| 25 x 15 | 0,8 |
| 30 x 15 | 0,6 |
Cleaning
Remove excess adhesive immediately with AT200 High Strength Cleaner. Ensure that the surface is solvent-resistant before cleaning. Cured adhesive can only be removed mechanically.
Note! SP050 is not suitable for bonding polyethylene, polypropylene, Teflon®, or nylon surfaces.
Bonding laminates and synthetic materials are also counter-indicated as they may be prone to cracking due to stresses.
Not suitable for use in glass joints (structural glazing).
Health and safety precautions
Safety data sheet must be read carefully before use.